13. Rewinder Module installation is complete.
完成背紙回收模組安裝。
14. Put the Motor Module on rear part of
printer and align it to 4 screw holes.
將馬達模組依圖上所示置於機器後端預留
的四個螺絲孔上。
15. Tighten but don’t fully tighten the screws to
save space for adjustment when installing
the belt.
將馬達模組固定螺絲半鎖於螺絲孔上，保留
可移動調整的空間，以方便裝設皮帶。
16. Adjust the position of Motor Module to
install the belt between Motor Module and
Rewinder Module. Fully tighten the screws
after the belt is installed correctly.
將皮帶依圖所示兩端分別套上馬達模組和
背紙回收模組，確認皮帶安裝無誤後即可將
馬達模組固定螺絲鎖緊。
17. Pull connection wires of Rewinder Module
inside of printer through the hole.
將背紙回收模組上的連接線組穿過孔洞，拉
入機器內部。
3
