3-3. Setting mode
In the Setting Mode, changes can be made according to requirement on the printing mode,
options, media type, and parallel interface (printer can only go into setting when connected to PC
by parallel cable, USB cable, or serial cable).
1.
Power on the printer and make sure it is on “Ready to print” status.
2.
Press and hold Pause key about 3 to 4 seconds until the buzzer beep 3 times, and then the
LCD will display “Setting Mode”.
3.
In the Setting Mode, the keys have the following functions:
: MINUS / Enter
: MENU / NEXT
: PLUS / Exit
4.
Before exiting the Setting mode, the LCD will prompt to ask whether save the settings or
not. After user’s response on whether do or do not save the settings, printer will exit from
Setting mode and return to standby mode.
Press and hold
key about 3 to 4 seconds until the buzzer beep 3 times and LCD shows
Setting mode. The LCD monitor will show different options on the bottom.
After entering to Setting mode, the first line
on LCD display indicates the setting item and
the second line is current value of setting.
Press "Enter" key to enter into one of setting
item, the current setting value will be marked
in black and other unselected values will be
listed in normal font.
In adjustment type of setting items, the first
line indicates the current item and the second
line indicates current value.
Plus: press
key to increase the value
Minus: press
key to decrease the value
Next: press
key to go to next item
EZPi-1000 User’s Manual
20
