Godex Label Printer User Guide
Page 21
19.
Click Close to end the install process.
1.
Push in the two buttons on either side of the cover and lift up to open the printer.
2.
Push in the two green buttons on the front of the black printhead assembly to release it. Then lift it up
out of the way of the paper path.
3.
Pull up on the spool axle to release it from the latch.
4.
The axle is set originally for a 1” core spool. It can also be switched to accommodate a 1.5” core spool
by flipping over the axle and turning it back to the original orientation across the printer. The sample
spool of labels that came with the printer is a 1” core spool.
5.
Place the spool of labels on the axle so that the labels will feed forward toward the front of the printer.
6.
Pull the two label guides apart and then feed the first label between them.
7.
Once the first label has been fed between the guides, push them gently together until they are snug
with the label, but not pinching.
8.
Return the black printhead assembly to its original position. It will snap into place.
9.
Close the lid of the printer so that it snaps back into place.
10.
Press the yellow feed button on the top of the printer to set the printer for the next label to print.
There is a video illustrating how to load the label paper stock at
http://www.youtube.com/user/GodexInternational#p/u/4/stdg2kWgi0c
