STE5 Operation Manual
29
6.
Place the left side of the
stripper first, and then fit
the right side.
7.
Hold the stripper module
and tighten the screws.
8.
Feed the label through
the Label Guides.
Note The label / paper used
for stripper is suggested to be
at least 25mm in height.
Suggestion
When printing
with stripper module, it is
suggested to set the stop
position (^E) to 9.
9.
Peel off the first label,
and feed the liner
through the roller and
the Tear-off Bar.
10. Follow the direction as
shown in figure to feed
the liner across the
stripper.
Summary of Contents for STE5
Page 1: ...P N 920 013911 00 Rev D 03 2013 ...
Page 35: ......
