Flat Five X - Version 2 (with 2 output jacks)
Specs:
Top nut: Tusq by Graphtech
Nut width: 1 11/16"
Scale: 24 ¾"
Radius: 16"
Tuners: High ratio Godin tuners
String gauge: Godin E-10 Nickel electric strings 10-46
Frets: Medium Jumbo Nickel
Pickups: 2 Godin humbuckers with LR Baggs bridge transducers
for acoustic sound.
Body: Silver leaf maple center with white poplar wings and a
grade A carved maple top.
Neck: Mahogany
Fingerboard: Indian rosewood
The Flat Five X adds an exciting new acoustic voice to the origi-
nal Godin Flat Five. A tight neck pocket fit, string-through body
design, mahogany neck and double chambered body are
responsible for the guitar's great tone and sustain. The Flat Five
X is powered by two Godin humbucking pickups and six saddle
transducers. The signal from the saddle transducers runs
through a custom pre-amp featuring a volume and three way EQ.
*Throughout this manual we refer to the humbuckers as magnet-
ics. The acoustic bridge pickups found on the Flat Five X are
referred to as bridge transducers.
Flexible Outputs
A look at the bottom of the Flat Five X reveals two ¼" outputs.
The output closest to the strap pin is a dual function jack. Used
on its own this serves as a mix out carrying the signal from the
bridge transducers as well as that of the magnetic pickups.
Separate volume controls on the guitar make it easy to mix the
two signals. The second ¼" jack carries the signal from the
magnetic pickups on its own. When a cable is plugged into the
magnetic pickup jack the magnetic pickup signal is removed from
the mix output so that there is now a separate signal for each of
the pickup systems.
One Cable in the Mix/Acoustic Output Jack
When using just one cable the signals from both pickup systems
are fed through the Mix/Acoustic output jack. The blend knob
allows you control the amount of magnetic vs. acoustic bridge
transducer sound that is heard through your amplifier. In the cen-
ter position an equal amount of magnetics and bridge transduc-
ers are output. Turning the knob clock-wise will increase the
amount of bridge transducer heard in the mix. Turning the knob
counter clock-wise will increase the amount of magnetic sound
heard in the mix.
Using Two Cables
As mentioned above in "Flexible Outputs" when two cables are
inserted into the output jacks the signals are completely separat-
ed and the blend knob becomes a volume control for the bridge
Output #2
Output #1
Fig. 1
Summary of Contents for Flat Five X
Page 1: ......