6
©Godiva Ltd. Our policy is one of continuous development. We therefore reserve the
right to amend specifications without notice or obligation.
INTRODUCTION
This manual contains information relevant to Godiva single or multi-pressure Prima
Series Pumps, when partnered with Compressed Air Foam Systems (CAFS)
FoamLogix Models
2.1A,
3.3,
5.0
and the SmartCAFS50 or 100 control system.
Distinction between the models regarding Installation, Maintenance, Operation and
Specification is clearly noted with text and illustrations.
For further information on the FoamLogix
2.1A,
3.3, 5.0
Foam Proportioning Systems,
MDTII Manual Dual Tank Selector (for 3.3, 5.0 systems) and Intelli-tank Water/foam
level display unit, please see the separate manuals supplied.
IMPORTANT NOTES
Please read this manual before operating the pump.
CRITICAL
: The pump Bearing Housing, Gearbox and Compressor are
NOT
filled with
oil ex works. Refer to section Installation and Set-up (Oil Filling Points) before operation.
Correct lubrication and maintenance is essential if satisfactory performance is to be
maintained.
Do not run the pump without water in the pump casing.
The terms ‘Left Hand’ (LH) and ‘Right Hand’ (RH) apply when the pump unit is viewed
from the suction tube end; for the purposes of this document, this is regarded as the
front of the assembly.
Model Identification System
Variations of the Godiva Prima pump with CAFS are identified thus:
P C 1 A 2010
!
Compressed air foam
1 = single pressure 2 = twin pressure
A = aluminium B = bronze
Godiva Prima series pump
2010 = 2000 l/min@10 bar. 3010 = 3000 l/min@10 bar
4010 = 4000 l/min@10 bar. Main pump output
