For Your Safety
- 17 -
extremely high temperature. Failure to observe this precaution could result in fire or
damage to the casing or internal parts.
Observe precautions when handling batteries
Batteries may leak or explode if improperly handled. Observe the following precautions
when handling batteries for use in this device:
Use only batteries listed in this manual. Do not use old and new batteries or
batteries of different types at the same time.
Read and follow all warnings and instructions provided by the manufacturer.
Batteries cannot be short-circuited or disassembled.
Do not put batteries into a fire or apply direct heat to them.
Do not attempt to insert batteries upside down or backwards.
Batteries are prone to leakage when fully discharged. To avoid damage to the
product, be sure to remove batteries when the product is not used for a long time or
when batteries run out of charge.
Should liquid from the batteries come into contact with skin or clothing, rinse
immediately with fresh water.
FCC WARNING
Any Changes or modifications not expressly approved by the party responsible for compliance could void
the user’s authority to operate the equipment. This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) This device may not cause harmful interference,
and (2) this device must accept any interference received, including interference that may cause
undesired operation.
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
Names of Parts
- 18 -
Body
Status Indicator Lamp
--
LED Red Color Lamp
Modeling Lamp/
Lock Setting Button
TEST Trigger Button
Select Dial
Micro USB Port
PC Sync Socket
Battery Compartment
Hot Shoe
Camera Connection
LCD Panel
Sound/
Delay Setting Button
Channel/
Sleep Setting Button
SET Button
Group/
PC Sync Socket
Setting Button
Power Switch
--
ON (Power On)
--
OFF (Power Off)
AF Assist Beam Switch
--
ON (AF Assist
Beam outputs)
--
OFF (AF Assist
Beam do not output)
