Gold Medal 2197NL, Instruction Manual

Lighted Nacho Cheese Warmer 

with

 Pump

M

ODELS

 #2197NL, #2197NR 

AND

 #2197NS

2

CARE AND CLEANING

Clean your machine daily. A clean well kept machine is one of the best ways of advertising your
product.

Use a mild soap and damp cloth to clean the exterior of the unit.

All utensiles and insert bowls should be cleaned with a sanitizing solution to help prevent contami-
nation from micro-organisms.

RECOMMENDED CLEANING PROCEDURE FOR MAIN PUMP BODY

1. Raise the pump assembly and lid out of the water tank. Operate pump to remove

remainder of cheese.

2. Place lower end of pump assembly in a bucket containing a mixture of hot water and

liquid dish detergent. Operate pump until cheese product is expelled and water flows
from discharge tube (approximately 10 pumps).  DO NOT RECIRCULATE DIRTY
WATER TO BUCKET!

3. Disassemble lid from pump assembly by loosening locking collar.  You will now have

the plunger, pump body and lid separate.  Wash lid and all exterior surfaces of pump.
Remove retaining pin from bottom of pump body to remove checkball.  Use supplied
tube brushes to clean pump body and discharge tube.

 NOTE: 

So as not to lose small

parts, wash them in a bucket filled with detergent water, not in a sink.

4. Push the spring stop disc toward the knob and hold plunger rod; loosen knob counter-

clockwise.  Disassemble plunger assembly in order to wash all components.

5. Rinse all parts with clean hot water.
6. Using a bucket, sanitize all parts with 100 parts/million sanitizing solution. Re-assemble

plunger assembly. Make sure knob is tight.

7. Remove parts from sanitizing solution; allow to air dry.
8. Install check ball and retaining pin. Insert plunger assembly into pump body and tighten

locking collar. (Lid assembly to pump not required.) Lower end of pump into sanitizing
solution and pump solution through pump, out of the container. Operate pump minimum
15 to 20 strokes.

9. Disassemble plunger assembly from pump and remove retainer pin and check ball. Allow

to air dry.  Reassemble.

10. Remove plug and check ball from bottom of pump and wash by hand.

Unplug the machine before cleaning.
Do not immerse in water.