Gold Medal 5280, Instruction Manual

3

5280 & 5280M SPIRAL SLICER 

 
INSTALLATION INSTRUCTIONS                                               

Inspection of Shipment: 

Unpack all cartons and check thoroughly for any damage that may have occurred 
during transit. Damage claims should be filed immediately with the transportation 
company. Gold Medal Products is not responsible for damage that occurs in transit. 

Setup: 

Your new 

SPIRAL SLICER  

is completely assembled and tested at the factory.   

Remove all packing material and tape before starting operation. 

Electrical Requirements (5280M): 

 
Voltage for the 5280M is 120 volt, 60 cycle single phase. The machine will draw a maximum of 
15 amps.  Your electrician must finish sufficient current for the proper operation of your 
machine. We recommend this machine be on a dedicated and protected circuit line.  
 
 

 
 
 
 
 
 
 
The 5280M has a current draw of 15 amps 

Your electrician must furnish sufficient power for proper machine operation. We 
recommend this slicer be on a dedicated and protected circuit.  Failure to wire properly 
will void the warranty and may result in damage to the machine. 

It is Gold Medal Products Company’s recommendation that this machine be plugged 
directly into a wall outlet.  The use of extension cords is not recommended due to 
safety concerns, and may cause sacrificed and/or reduced performance.