Econo 8 Popcorn Machine
Model No.: 2388, 2388-00-002
Page 15
gmpopcorn.com
Replacing Broken Glass
Broken glass panels can be easily replaced. Gold Medal
Products Co. does not ship glass. It can be
obtained from a local glass shop, always purchase tempered glass.
GLASS
DIMENSIONS
(Height x Width x Thickness)
Front
Glass:
22 3/8” X 16 15/16” X 1/8” (1 Piece)
Side
Glass:
22 3/8” X 14 15/16” X 1/8” (2 Pieces)
1.
Turn machine OFF, unplug unit and allow it to cool before attempting to replace glass.
2.
Remove all loose pieces of glass (popper units: kettle may be removed to change glass).
3.
Place a bungee (or large rubber band) around the unit to help hold the corner posts in
place, then remove dome.
4.
Remove all rigid glass channels from around glass to be replaced, set channels aside
for reuse.
Note:
The rigid channels may be wedged in the corner posts or top and bottom glass
extrusions, and must be removed before new glass can be installed.
5.
Carefully remove the rest of the broken glass.
6.
Apply decals (if desired) to new glass panel.
7.
Slide rigid glass channels over exposed sides and bottom of new glass panel.
8.
Lift motor plate just enough to allow the new glass panel to slide into the corner posts
and down into the bottom glass extrusion.
9.
Carefully lower the motor plate until the top glass extrusion secures glass in place.
10.
Reinstall dome, and remove bungee (popper units: reinstall kettle if removed).
