Econo 8 Popcorn Machine
Model No.: 2388, 2388-00-002
Page 9
gmpopcorn.com
Care and Cleaning
DANGER
Machine must be properly grounded to prevent electrical shock to personnel.
DO NOT immerse in water.
DO NOT clean appliance with a water jet.
Always unplug the equipment before cleaning or servicing.
025_111616
WARNING
To avoid serious burns, DO NOT touch the kettle while it is hot!
028_082715
Good sanitation practice demands that all food preparation equipment be cleaned regularly (only
use non‐toxic, food grade cleaners). A clean looking, well‐kept machine is one of the best ways of
advertising your product.
Note:
It is extremely important to follow all of the cleaning procedures, otherwise parts
damage and equipment failure will result. The warranty does not cover parts that
are damaged due to improper cleaning.
Daily Kettle Cleaning Instructions
CAUTION:
A hot kettle will cause burns if you touch it with your hand. Allow kettle to cool
at least 1 hour before attempting to clean.
DO
NOT
use ice or water to cool
down a hot kettle! Severe kettle damage will result!
1.
When cool, wipe the
outside
of the kettle with a clean, soft cloth.
DO
NOT
use oven
cleaners or abrasive materials as they will damage the kettle.
2.
Every night, mix Gold Medal’s Heat’n Kleen solution (Item No. 2095), 2 tablespoons
per gallon of water. It is not necessary to use the entire gallon at once; only use
enough to fill the kettle 1/2 inch deep.
3.
Turn the kettle heat ON. When the water starts to boil, turn the kettle heat OFF.
4.
Allow to cool for at least 1 hour, then dump the solution into a bucket and wipe the
inside of the kettle with a clean cloth. Make sure all of the solution goes into the
bucket; do not spill any in the interior of the machine.
For extra dirty kettles, the process may be repeated; or, after turning the kettle heat
OFF, allow solution to sit in the kettle overnight. The next morning, dump the solution
into a bucket and wipe the inside of the kettle with a clean cloth.
5.
With the unit OFF and unplugged, wipe the kettle lead cord with a clean SLIGHTLY damp
cloth.
DO
NOT
get
moisture
into
the
kettle
lead
‐
in
cord,
severe
damage
will
result.
