Pop-A-Lot
Model No. 2007, 2007BN, 2007ST, 2007EX, 2007STX
Page 6
gmpopcorn.com
OPERATING INSTRUCTIONS
Controls and Their Functions
LIGHT SWITCH
– Turns on the dome light and the interior heat light.
WARMER SWITCH
– Turns on the heat to the bottom corn pan.
KETTLE MOTOR SWITCH
– Turns on the motor which drives kettle agitator shaft and the
exhaust blower in the popper dome.
KETTLE HEAT SWITCH
– Turns on the heat element in the popcorn kettle.
Amount of Popcorn and Oil
Your new popper is equipped with a corn, salt, and oil measure cup. We recommend flavored and
colored coconut oil. Popcorn popped in coconut oil stays fresh longer and does not leave black
deposits in your kettle like other oils. Use only top quality, fresh popcorn from reputable suppliers.
Corn charge – 8oz.
Oil charge – 1/3 Cup (2 2/3oz.)
Flavacol – 1 Teaspoon
For best results use 8oz. mega-pop premeasured pouches (Item# 2838)
Popping Instructions
1.
Turn both the kettle heat and kettle motor switches “ON.”.
2.
Test pop three kernels of corn and one ounce of popping oil. When the kernels pop,
the kettle is ready for use.
3.
Load both a full corn/oil charge and Flavacol seasoning salt into the kettle. Close the lids.
4.
When the corn has finished popping, gently dump the kettle.
5.
Repeat the cycle, starting with step number 3, until the desired amount of popcorn has
been achieved. Always pop 3 to 5 consecutive batches for the best popcorn.
6.
On the final kettle of corn, it is a good idea to turn the kettle heat switch “Off” just as
the lids are forced open by the popping corn. This procedure saves electricity since the
kettle has plenty of heat and eliminates smoke/odor from any oil residue that remains
after you have stopped popping.
NEVER LEAVE THE HEAT ON WHEN YOU ARE NOT POPPING!
Light
Switch
Kettle Motor
Switch
Kettle Heat
Switch
Warmer
Switch
