Spartan
Model No.2671
Page 4
gmpopcorn.com
INSTALLATION INSTRUCTIONS
Inspection of Shipment
After unpacking, check thoroughly for any damage which may have occurred in transit. Claims
should be filed immediately with the transportation company. The warranty does not cover
damage that occurs in transit, or damage caused by abuse, or consequential damage due to the
operation of this machine, since it is beyond our control (reference warranty in back of manual).
Manual
Read and understand the operator’s manual and all other safety instructions before using this
equipment. To order copies of the operator’s manual go to gmpopcorn.com or write to Gold
Medal Products Co., 10700 Medallion Drive, Cincinnati, OH 45241 USA 1-(800)-543-0862.
Setup
Your new Spartan is completely assembled and tested at the factory. Remove all packing
material and tape before starting operation.
Electrical Requirements
DOMESTIC UNITS: 120/208 V~ or 120/240 V~, 7177 W, 60 Hz
Domestic units are designed to operate on single phase, 50 AMP, 4 wire supply, 120/208
or 120/240 V~ (2 Hot, 1 Neutral, 1 Ground). All electrical components in this machine are
120 V (motors, heat elements, lights, etc.) and therefore require “Hot to Neutral”
connection (NOT “Hot to Hot”). A 50 AMP wall receptacle (NEMA 14-50) is supplied with
the machine. The receptacle will accept the attachment plug on the machine and must be used.
Reference the Receptacle Installation instructions for wiring the NEMA 14-50 Receptacle.
EXPORT UNITS: 230 V~, 7177 W, 50 Hz
Export units are designed to operate on single phase, 16 AMP, 4 wire supply, 230 V~ (2
Hot, 1 Neutral, 1 Ground). All electrical components in this machine are 230 V (motors,
heat elements, lights, etc.) and therefore require “Hot to Neutral” connection (NOT “Hot to
Hot”). A certified electrician must supply and install the wall receptacle for this unit;
reference the Receptacle Wiring Diagram for Export Units.
DANGER
Machine must be properly grounded to prevent electrical shock to personnel.
Failure to do so could result in serious injury, or death.
DO NOT immerse any part of this equipment in water.
DO NOT use excessive water when cleaning.
Keep cord and plug off the ground and away from moisture.
Always unplug the equipment before cleaning or servicing.
Make sure all machine switches are in the OFF position before plugging the
equipment into the receptacle.
008_051514
