Tornado SHO
Model No. 3007, 3007A, 3007EX
Page 14
gmpopcorn.com
7.
Inspect, then clean or replace the band and ribbon(s). The primary reason for ribbon
replacement is carbon build up inside the ribbon; an additional hot water soak may
help remove some of the carbon buildup.
8.
When the sugar has been removed, allow the band and element(s) to air dry overnight.
Note:
For models with separate heat and motor switches, the best way to dry the floss
head after reassembly is to spin it dry for 10 minutes
WITHOUT HEAT
(use
motor switch only).
Reassembly of Floss Band – Units with Terminal Assemblies
(See next page for Export Units with Terminal Jumper.)
1.
Reinstall band and ribbon(s) on the spinner head; ALWAYS attach one ribbon element
lead to each terminal assembly (see image below).
2.
Reassemble terminal guard, lock nut, and nylon acorn nut.
3.
When reinstalling the spinner cap,
DO NOT OVERTIGHTEN SCREWS
. Initially snug
down each screw evenly, be careful not to over apply pressure on any single point and
crack the band coating. Once snug, tighten all screws evenly to secure spinner cap to
floss head.
Terminal Assemblies
INCORRECT
DO NOT
connect both ribbon element
leads to the same terminal assembly.
CORRECT
Connect
ONE
ribbon element lead
to
EACH
terminal assembly.
General double ribbon view shown for reference, Models may vary.
Double Ribbon Floss Head with Terminal Assemblies
