Tornado SHO
Model No. 3007, 3007A, 3007EX
Page 5
gmpopcorn.com
Electrical Requirements
The following power supply must be provided for your Floss Machine:
3007, 3007A:
120 Volts, 2400 Watts, 60 Hz.
3007EX:
230 Volts, 2400 Watts, 50 Hz.
DANGER
Machine must be properly grounded to prevent electrical shock to personnel.
Failure to do so could result in serious injury, or death.
DO NOT immerse any part of this equipment in water.
DO NOT use excessive water when cleaning.
Keep cord and plug off the ground and away from moisture.
Always unplug the equipment before cleaning or servicing.
Make sure all machine switches are in the OFF position before plugging the
equipment into the receptacle.
008_051514
A certified electrician must furnish sufficient power for proper machine operation and install any
supplied receptacle. We recommend this equipment be on a dedicated and protected circuit.
Failure to wire properly will void the warranty and may result in damage to the machine. It is Gold
Medal Products Co.’s recommendation that this machine be plugged directly into a wall outlet. The
use of extension cords is not recommended due to safety concerns, and may cause sacrificed
and/or reduced performance. Make sure cord is located to prevent a trip hazard or unit upset.
Before You Plug In Machine
1.
Make sure all machine switches are in the OFF position before plugging the equipment
into the receptacle.
2.
Make sure the wall outlet can accept the grounded plugs (where applicable) on the
power supply cord.
3.
The wall outlet must have the proper polarity. If in doubt, have a competent
electrician inspect the outlet and correct if necessary.
4.
DO NOT use a grounded to un-grounded receptacle adapter (where applicable).
5.
Install the unit in a level position.
CAUTION
If the supply cord is damaged, it must be replaced by Gold Medal Products Co.,
its service agent or similarly qualified persons in order to avoid a hazard.
039_080614
