Assembly Procedure
Page 16
Step 13.
The Patio Heater is intended to be used with a standard 9kg LPG cylinder. This is the type of
cylinder that can be refilled at petrol station or swapped for similar cylinder.
Place the cylinder in position into the stand, ensuring that the cylinder sits flush on the ground inside
the unit.
Take the hose that came with the Patio Heater, check that it has a rubber seal on the regulator end
of the hose and connect this end to the gas cylinder, ensuring that the hose is not twisted. You
won’t need a spanner here. Just turn the fitting in an anti clockwise direction and hand tighten as
much as you can. This should seal it sufficiently.
It is important to conduct a leak test prior to use. Follow leak test procedure.
(
Procedure
located on Page 2 of this manual)
Important: The hose must not be kinked or twisted.
