Installing your Towel Warmer
7.
Mark the centers on the wall, note that the towel rail
should be installed so that the bottom rail is at least
600mm above floor level.
6.
Hold the towel rail against the wall in the location where
you want the towel rail mounted. Ensure it is located
parallel using a spirit level. Using a pencil, mark the four
legs position on the wall.
1.
Feed a short Screw (#9) through the middle of the upper
leg (#1). There is a locator hole at the base end which this
screw should line up with and pass through.
2.
Align the short screw with the locator of the upper leg
positions on the towel rail, ensure grub screw is facing
down.
Tighten so that the legs are secured onto the
upright tube. Do not overtighten, leave just enough give to
allow the leg to rotate and align parallel with other legs.
3.
Repeat steps 1 & 2 to attach the second upper leg
5.
The last lower leg should be installed either in a concealed
or exposed manner, as per the previous page.
4.
Remove the screw from the towel rail and fit through the
lower leg (#2) and re-fit to the towel rail.
NOTE: Use the lower leg with the cutout for the side (either left
or right) where the power cable is located.
B
A
C
D
600mm
