MOUNTING INSTRUCTIONS
You must next select which side of the towel rail is needed to be wired in. The heated towel rail
within this box has two wiring options (left or right hand). The location of existing wiring
through or on the wall will dictate which side you will use.
For Left hand wiring, use the power cable from Point A.
Then shorten cable to the desired length for termination.
For Right hand wiring, use the power cable from Point B.
Then shorten cable to the desired length for termination.
For the side that you do not use, cut the power cable off
as close to the white plastic lock that it comes through in
the towel rail. The two power cables are not connected
to each other.
Installing your Towel Warmer
A
B
Select desired position to mount towel rail with at least 300mm clearance from all permanent
objects in surrounding area and 600mm above the floor. The Ladder Towel Rail should be
installed in accordance to local governing ASNZS regulations. The Goldair Heated Towel Rail can
only be mounted 1 way. Your towel rail is mounted by legs with a single screw on each of the 4
legs as indicated in the illustration below.
SIDE VIEW OF TOWEL RAIL
TOP VIEW OF TOWEL RAIL
LEGS
LEGS
