Operating Your Dehumidifier
TANK FULL INDICATOR
When the tank is full, the unit will stop running, and the Full indicator light will flash.
Grip the tank by its handles and carefully pull out.
Empty the water tank and reinsert it into the dehumidifier.
The tank must be in place and securely seated for the dehumidifier to operate again.
The dehumidifier will re-start when the tank is restored to its correct position.
CONTINUOUS DRAINAGE
This dehumidifier has a continuous drain hole that can be connected to a plastic pipe
with a 15 mm inner diameter (Supplied in the packing).
Water can be smart plumbed in or drained into a sink, a larger receptacle or through
the wall into an outside drain. Please follow the steps below to set your unit up for
continuous drainage.
•
Cut off the cover for the continuous drain on the back of the unit.
•
Pull out the water tank and connect a water tube of inner diameter 15mm to the
drain connector, and ensure the connection is tight.
•
Return the water tank back into position within the unit.
This unit uses gravity to drain the water. The drain should be lower than the
dehumidifier water outlet. Be sure to run the water pipe downward and let the water
flow out smoothly. Do not kink or bend the pipe.
Summary of Contents for GPDH480
