FREE STANDING
1.
Ensure the heater is unplugged and power
switches are off.
2.
Set heater upside down.
3.
Align the screw hole on the Castor Wheel
bracket with the screw hole on the base of
the heater.
4.
Attach Castor wheel bracket with the winged
screws provided and ensure the bracket sits
firmly in place (do not over tighten). Firmly
press Castor Wheels into the slots provided
on the Castor Wheel bracket.
5.
Set heater upright and plug into a standard
240 volt AC electrical outlet.
The screw pack to attach the feet to your heater
will be taped to either one of the feet for your
heater.
WALL MOUNTED
1.
Make sure the heater is unplugged and
power switches are off.
2.
Position the panel heater within one metre of
a wall socket. Do not mount in front of or
below the wall socket. Ensure there is at least
150mm clearance on all sides of the heater.
3.
Detach the mounting bracket from the back of
the panel heater by unscrewing the two
locking screws (located on the top of the
mounting bracket).
4.
Position the mounting bracket on the wall and
mark the hole positions with a pen or pencil
and check they are horizontal with a spirit
level. Ensure the two bottom mount holes are
at least 150mm from the floor and drill holes
as required.
5.
Secure the mounting bracket to the wall with
the four mounting screws. (For masonry walls
use the plastic sheaths).
6.
Slot the back of the heater onto the mounting
bracket locating the bottom plugs first and
secure with two locking screws.
7.
Plug heater into a standard 240 volt AC
electrical outlet.
WALL MOUNTING POSITION
Installing Your Panel Heater
