12
ASSEMBLY
Unpacking
• Remove all packaging materials.
• Remove remaining packing and package inserts (if included).
• Check that the package contents are complete.
• Check the appliance, the power cord, the power plug and all accessories for
transportation damage.
• Keep the packing materials as long as possible until the end of the warranty
period.
WARNING
Packaging materials are not toys! Children must not play
with plastic bags!
Danger of suffocation!
FITTING THE CUTTING DISC (FIG.1-4)
• Unplug the tile cutter from the mains supply.
• Raise the 45° vertical fence (1) approx. 45° and remove.
• Loosen cross-screws (2) with the star-head screwdriver
(not supplied) and pull off lower protective guard (3).
• Attach the straight wrench (4) (supplied) to the hex nut (5).
• Lock motor shaft (6) to prevent turning using angled
wrench (7) (supplied).
• Turn the hex nut (5) anti-clockwise.
• Remove the hex nut (5) and outer flange (8).
• Place cutting disc (9) on inner flange (10).
• Attach the outer flange (8), the double “D” flats on the
outer flange align with flats on motor shaft.
• Screw hex nut (5) onto motor shaft (6) clockwise.
• Attach the straight wrench (4) to the hex nut (5).
• Lock motor shaft (6) to prevent turning using angle
wrench (7).
• Tighten hex nut (5) clockwise using straight wrench (4).
• Re-attach the lower protective guard (3) and tighten
cross-screws (2).
WARNING !
Be sure to observe the rotational direction of the cutting
disc when fitting! Be sure to observe the free-wheeling
of the cutting disc when fitting!
3
2
2
fig.2
5
6
8
9
10
fig.4
fig.1
1
fig.3
6
5
6
7
4
8
5
