CAN-bus Cruisecontrol GC90Ci installation manual
11
4.2
Release procedure
The GC90Ci is secured with an release procedure, this procedure checks if there is a
proper CAN-bus brake signal available and properly programmed. The Cruisecontrol
askes you with beep-signals to press and release the brake pedal. This procedure needs
to be performed once after installation.
Read this procedure carefully before performing it.
Step
Action
Confirmation
1
Switch the ignition OFF and ON (do not start!)
2
Switch the Cruisecontrol ON
2 beeps low
3
Operate and holt it during step 4
Immediately after step 4, there are 3 long beeps audible perform then the following
action:
Beep audible Press the brake
Beep stops Release the brake, do this with all 3 beeps
4
Press the brake pedal 4 times and release
4 beeps
Immediately after step 4 the beeps starts
3 long beeps
5
Beep: Press the brake
CM-LED orange
6
Beep stops: Release the brake
CM-LED green
The Cruisecontrol is released:
4 beeps
The Cruisecontrol isn’t released:
4 high-low beeps
When the Cruisecontrol isn’t released, do step 1-6 again before contacting your
supplier
When this release procedure isn’t done correctly, the Cruisecontrol doesn’t operate, it is
however possible to:
-
Learn the accelerator, learn the speed signal (not necessary with GC90Ci)
-
Do the self-diagnostic
-
Use the speed limiter (when programmed)
