4
LIGHTING INSTRUCTIONS FOR
“S-MODEL” SKYTECH REMOTE HI-LO MOTOR MODELS
To Turn OFF Gas To Appliance
1.
Turn off switch or remote.
2.
Remove Decorative Front
3.
Turn control knob clockwise to “PILOT”
4.
Depress control knob slightly and turn
clockwise to “OFF”
A.
The Golden Blount appliance has a pilot which must
be lit by hand. When lighting the pilot, follow these
instructions exactly.
B.
Before Lighting, smell all around the area for gas. Be
sure to smell next to the floor because some gas is
heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS
•
Do not try to light any appliance.
•
Do not touch any electrical switch, do not use any
phone in your building.
•
Immediately call your gas supplier from your
neighbor’s phone. Follow the gas supplier’s
instructions.
•
If you cannot reach your gas supplier, call the fire
department.
C.
Use only your hand to push in or turn gas control
knob. Never use tools. If the knob will not push in or
turn by hand, don’t try to repair it. Call a qualified
service technician. Force or attempted repair may
result in fire or explosion.
D.
Do not use the appliance if any part has been under
water. Immediately call a qualified service technician
to inspect the appliance set and to replace any part of
the control system and any gas control system and
any gas control which has been under water.
E.
FIREPLACE DAMPER MUST BE FULLY OPENED.
FOR YOUR SAFETY,
READ BEFORE LIGHTING
Pilot Burner Location
Decorative Front
Screw
Remote Control
Connector
1.
“Stop!”
First read the safety information
at the left.
2. Remove two screws from sides of burner
and take off decorative front to access
control valve.
3. Turn the control to the “OFF” position. To do
this, you must turn the knob clockwise
to the “PILOT” position and then press
in and continue turning clockwise to the
“OFF” position.
4.
WAIT FIVE (5) MINUTES TO CLEAR
OUT ANY GAS.
If you then smell gas, STOP! Follow step
“B” in the safety information at the left. If
you don’t smell gas, go to the next step.
5. To put the control in the pilot position, turn
the control knob counter-clockwise to
the“PILOT” position.
6. To light the pilot, depress the control knob
and light the pilot using a long match or
extended butane lighter. The control knob
should be held IN for 1 minute.
7. Release the control knob. The pilot should
remain lit after releasing.
8. Turn the control knob counter-clockwise
to the “ON” position.
9. Connect RCAF-1031 Remote control
receiver to connector on control valve and
position receiver behind burner assembly
on floor of fireplace.
10. Replace decorative front and follow
operation instructions supplied with
RCAF-1031 Remote Control.
I G
A
A
I G
WARNING:
WARNING:
IF YOU DO NOT FOLLOW
THESE INSTRUCTIONS EXACTLY, A FIRE
OR EXPLOSION MAY RESULT CAUSING
PROPERTY DAMAGE, PERSONAL INJURY
OR LOSS OF LIFE
Control
Knob
