Golden Blount LFP4218, Installation And Operating Instructions Manual

12

Upon completing the gas line connection, a small amount of air will be in the lines. 

When 

 lighting the pilot light, it will take a few minutes for the lines to purge  

themselves of this air. Once the purging is complete, the pilot and burner will light and 

operate as indicated in the instruction manual. Subsequent lighting of the appliance 

will not require such purging.

WARNING:

CHILDREN AND ADULTS SHOULD

BE ALERTED TO THE HAZARDS 

OF HIGH SURFACE TEMPERATURE AND SHOULD STAY

AWAY TO AVOID 

BURNS OR CLOTHING

IGNITION. YOUNG CHILDREN SHOULD BE

CAREFULLY 

SUPERVISED WHEN THEY ARE IN

THE SAME ROOM AS THE APPLIANCE.

IMPORTANT: TURN OFF GAS BEFORE SERVICING APPLIANCE. IT IS RECOMMENDED 

THAT A COMPETENT SERVICE TECHNICIAN PERFORM THESE CHECKUPS AT 

THE BEGINNING OF EACH HEATING SEASON.

WARNING: THE FLOW OF COMBUSTION AND VENTILATION AIR MUST NOT  

BE OBSTRUCTED.

When lit for the 

 time, the appliance

will emit a slight odor for an hour or two.

This is due to paint and lubricants used

in the manufacturing process. The main 

burner 

 characteristics are steady,

not lifting or 

 Typically, the top 

1/4 inch of the 

 sensor should be

engulfed in the pilot 

 A periodic 

check of these characteristics is  

necessary (Figure 12.2).

Figure 12.2

OPERATING GUIDELINES

Flame

Sensor

GLASS  FLAME  STABILIZER  INSTALLATION  CONT.

3.  GLASS  FLAME  STABILIZER  SHOULD  BE  SEATED  AGAINST  FIREPLACE  FLOOR  AS  SHOWN

f i r e - p a r t s . c o m