Golden Blount LFP4218, Installation And Operating Instructions Manual

BUILDING CODES AND SAFETY STANDARDS

The design of this FIREPLACE has been tested and is listed with PFS CORPORATION

in accordance with THE AMERICAN NATIONAL STANDARDS INSTITUTE —  
ANSI Z21.50-2014.

This manual serves only as a basic guideline for installation and use of this 

and gas piping. The complete installation must be in accordance with local codes and 
ordinances, or, in the absence of local codes, with the American National Standards 
Institute National Fuel Gas Code Z223.1 latest edition.

GENERAL INFORMATION

DESIGNED TO BURN BY DRAWING COMBUSTION AIR FROM THE OUTSIDE AIR KIT THAT
ATTACHES TO THE SIDE (SIDES) OF THE FIREPLACE.

THE EXHAUST FLUE GASES ARE TO BE VENTED THROUGH THE TOP-VENT USING 
8" OR 10” B-TYPE GAS VENT PIPE.

THE CONTROL SYSTEM IS A (3V) SPARK TO PILOT TYPE THAT INCLUDES A
ON-OFF SHUTOFF VALVE, A GAS CONTROL VALVE, A SPARK TO PILOT LIGHT
ASSEMBLY, AND ON-OFF ROCKER SWITCH. 

WARNING:

 THIS UNIT IS NOT FOR USE WITH SOLID FUEL.

NOTE:

 INSTALLATION AND REPAIR SHOULD BE DONE BY A QUALIFIED SERVICE 

PERSON. THE APPLIANCE SHOULD BE INSPECTED BEFORE USE AND AT LEAST 
ANNUALLY BY A PROFESSIONAL SERVICE PERSON. MORE FREQUENT CLEANING 
MAY BE REQUIRED DUE TO EXCESSIVE LINT FROM CARPETING, BEDDING 
MATERIAL, ETC. IT IS IMPERATIVE THAT THE UNITS CONTROL COMPARTMENT, 
BURNERS, AND CIRCULATING AIR PASSAGE-WAYS BE KEPT CLEAN TO PROVIDE 
ADEQUATE COMBUSTION AND VENTILATION AIR.

CLEARANCES REQUIRED

MINIMUM CLEARANCES FOR THE FIREBOX ARE:

1/2" ON THE SIDES AND BACK AND 0 AT THE BOTTOM. TOP CLEARANCE IS 3" 

NOTE: 

PROVIDE ADEQUATE CLEARANCES AROUND AIR OPENINGS INTO THE 

COMBUSTION CHAMBER.

NOTE: 

ADEQUATE ACCESSIBILITY CLEARANCES FOR SERVICING AND PROPER 

OPERATION MUST BE PROVIDED IN ACCORDANCE WITH ANSI Z21.50-2014.

5

MODELS  LFP4218,6018 

&

7

218  ARE  TOP  VENTED  GAS  FIREPLACES.  THEY  ARE

WHICH  IS  THE  HEIGHT  OF  TOP  STANDOFFS,  (LFP4218),  3”  (LFP6018/

7

218).

f i r e - p a r t s . c o m