Golden Blount LFP9618, Installation And Operating Instructions Manual

14

FOR YOUR SAFETY READ BEFORE LIGHTING

WARNING:

 IF YOU DO NOT FOLLOW THESE INSTRUCTIONS EXACTLY,

A FIRE OR EXPLOSION MAY RESULT CAUSING PROPERTY DAMAGE,  
PERSONAL INJURY OR LOSS OF LIFE.

A.

This appliance is equipped with an ignition device which automatically lights the

pilot. Do not light pilot by hand.

B.

BEFORE LIGHTING smell all around the appliance area for gas. Be sure to smell

next to the 

 because some gas is heavier than air and will settle on the

WHAT TO DO IF YOU SMELL GAS:

• Do not try to light any appliance
• Do not touch any electric switch:
• Do not use any phone in your building.
• Immediately call your gas supplier from a neighbor’s phone. Follow the gas

supplier’s instructions

C.

Do not use this appliance if any part has been under water. Immediately call a

 service technician to inspect the appliance and to replace any part of 

the gas control system which has been under water.

LIGHTING INSTRUCTIONS ELEC. SPARK TO PILOT

NOTE: DAMPER CONTROL LEVER MUST 

BE IN THE “OPEN” POSITION TO IGNITE.

GAS VALVE

An approved Power Vent Fan must be installed prior to operating this Fireplace. See        

page 8 of this manual for fan information.

D.

1.

“STOP” Read  the safety information

above.

2.

After installing Enervex RS-14 Power

Vent and Proven Draft Switch you can

proceed with lighting of this Fireplace

3.

Set the  switch to “OFF”.

4.

Remove batteries from battery pack.

5. This 

appliance is equipped with an 

ignition

device which automatically 

lights the

burner. Do not try to light the 

burner

by hand.

6.

Wait (5) minutes to clear out any gas.

Then smell for gas, including near the

floor. 

If you smell gas, STOP! Follow 

“B” in

the safety information 

above

. If

you don’t smell gas, go to next step.

7.

Install (2) D batteries in battery pack.

8.

Turn ON/OFF rocker switch to " ON".

9.

If the appliance will not operate, follow

the instructions “To turn Off Gas To

Appliance” and call your service

technician or gas supplier.

NOTE: 

THIS  FIREPLACE  CAN  ALSO  BE 

SERVICED  WITH  120V  JUNCTION  BOX 

AND  3-VOLT  TRANSFORMER  WHICH 

CAN  BE  USED  TO  PROVIDE  POWER  IF 

DESIRED (PART# JB-3V).