18
RESET button to reset the power supply. The RESET button is on the same side of the power supply
as all the heater cord connections. Attempt to turn the sauna on at the control panel. Contact
the manufacturer for any additional troubleshooting.
Solution:
There could be damage to the temperature sensor. If your sauna arrived with a spare temperature
sensor, turn the control panel off and go to the roof of the sauna and locate the red and black wire near the air
vent towards the rear of the sauna.
After you have located the red and black wires labeled “TEMP SENSOR”,
disconnect them. Connect the spare temperature sensor
. For testing purposes, insert the “TEMP SENSOR”
(you just connected) down the vent on the roof so that it is now inside the sauna. Then go to the control panel and
press the power button. If the heat emitters now heat, then the temperature sensor was the cause of the
problem. You may have to wait about five minutes to confirm if the heat emitters are generating heat. Remove the
original temperature
sensor from its hole and replace it with the spare one.
Solution:
Check the wiring harnesses coming from the power supply located on the roof of the sauna. Make sure
the wirin
g harness labeled “CTRL” is connected to the power supply at one end and connected to another wiring
harness labeled “CTRL” at the other end. If this wiring harness is not properly connected, then the sauna will
show signs of having no power.
