Golden Embers Wood Fired Ovens, Installation And Operating Manual

GOLDEN EMBERS

GAS BOOSTER KIT

 - 

PART NUMBER AC11

 
OPERATING INSTRUCTIONS: 
 
 

1.  Turn on gas main ball valve. Turn so that handle is in line with pipe to open. 
2.  Switch on Main Switch on control panel to Power On Position – The power light illuminates 
3.  Turn Switch to burner on position 
4.  Automatic ignition cycle begins. 
5.  If ignition sequence fails the flame failure light will illuminate and the system will lock out. 
6.  If flame failure light is illuminated then switch the system off and on and cycle will restart automatically. 
7.  Pilot indicator will illuminate once started and the main burner indicator will illuminate when operating 
 
 

SET THE OPERATING TEMPERATURE: 
 

1.  With the main switch on and the temperature display illuminated - 
2.  Press the set button once. The Out1 light will flash 
3.  Adjust the temperature up or down by means of the up or down arrows 
4.  Do not touch the buttons for 10 seconds. The new setting will be stored. 
5.  To change the operating parameters - call your supplier or carefully follow the instructions in the detailed 

instruction sheet. Be aware that improper settings can have a significant impact on operation. 

TROUBLE SHOOTING 
 

SYMPTOM ACTION 

No sparking and switches do not illuminate. 

Check that mains lead is plugged in. Check that mains 
is on at wall socket. Check that circuit breaker on control 
box is not tripped. If tripped press back in. Check that 
there is power to that wall socket. If still not functioning 
then turn of gas ball valve and call your supplier. 

Igniter sparks repeatedly, no pilot flame lights and 
reset light comes on. 

Try again, there may be air in the line, if still u

nsuccessful

then check that ball valve is open and that the gas 
supply is functioning. If all checked then check that 
spark is going to pilot head, not to ground somewhere 
else. If still not functioning check cables to BM valve 
securely plugged in.  If all these checks fail - shut ball 
valve and call your supplier 

Pilot flame lights briefly then goes out and reset 
light comes on. 

Check that the flame rod (longer one) is in the pilot 
flame. If pilot flame does not reach the flow will need to 
be adjusted. If that side of pilot is not ignited (2 sides 
burning only) then the head needs cleaning or the 
airflow needs to be corrected. If all else fails switch off 
the gas at the ball valve and call your supplier. 

Pilot Flame lights but main burner does not ignite 

If you can hear or smell gas or there is a flame at any 
point other than at the burner head - shut down the gas 
supply immediately - the burner tube has been blocked 
by foreign matter and must be dismantled and cleaned  
 
If there is no gas flow to the main valve - check that the 
temperature controller has been appropriately set. If 
everything appears correct then call your supplier. 

If the burner “roars” and the flame originates in 
the burner tube and not at the burner head 

The air mix is incorrectly set. Adjust until you get a 
strong clear blue silent flame or shut off gas and call 
your supplier. 

Any other abnormal behaviour of the system 

Immediately shut the gas supply and call your supplier.