USER
’S MANUAL
26
7 SETTING
7.1 Ethernet Config
Through the Ethernet Config item you can carry out Ethernet related settings.
Highlight the Ethernet Config item in the Setting menu and then press
OK or RIGHT keys to
enter the Ethernet Config menu. This menu has five items, see the figure below:
Ethernet Config
Link Type:
Select to use either Wire Network or Wireless Network.
Config:
Select the network connection method. After entering this item, network
connection methods and related information can be found.
In which, the first item, Config Mode, is to select a network connection method. There
are four methods: Bootp, PPPoE, Static IP and DHCP. DHCP is the default method.
If the PPPoE method is chosen, the PPPoE Set item at the bottom will become
active (see the figure below). After entering this item, a user name and password
input interface will appear.
If the Static IP method is chosen, the IP Address, Netmask, Gateway and DNS
Server items will become active (see the figure below). Users can establish the
network connection by giving these parameters.
After setting, press EXIT key to return to the Ethernet Config menu.
Ping Test:
Through this item you can test the connection state to the target IP address.
After entering this item, the following menu appears. In which, the Times item is to set
the times the Ping test will be carried out.
Preferred Storage:
When there are several storage devices connected, you can
through this item select one of them to store network data while in Network Mode.
MAC Address:
Not configurable, showing the MAC address of the network adapter
card.
7.2 Factory Reset
Through the Factory Reset item you can reset the system to factory settings.
