ALANTE DX/LT_SG_REVA_030112
23
Figure 10. Frame with motor/brake and power module.
POWER MODULE
1. Turn off power.
2. Place the power chair in drive mode.
3. Disconnect the bus cable coming from the joystick.
4. Remove the seat and seat post.
5. Remove the battery box.
6. Remove the (red metallic) body shroud by removing the (8) Phillips head screws from the bottom side of the
frame.
7. Disconnect the motor harnesses M2 and M1, the power harness, and the bus cable from the power module.
8. Remove the power module from the frame, by removing the (2) bolts securing it. See figure 10.
9. Install the new power module onto the frame.
10. Reconnect the motor harnesses M2 and M1, the power harness, and the bus cable to the new power module.
11. Reinstall the (red metallic) body shroud and secure.
12. Reinstall the battery box.
13. Reinstall the seat.
14. Reconnect the bus cable coming from the joystick.
15. Power on and test the power chair.
Power Module
Motor/Brake Assembly
Allen head bolts (3)
Power Module Bolts (2)