Buzzaround XL_SG_REVA_100711
40
BEEP CODE #7 - PADDLE FAULT/SPEED CONTROL FAULT (VOLTAGE ERROR)
2.5k ohms +/- 10%?
Outside that range?
Yes
Are either reading outside that range?
Remove
the seat.
Remove
the battery
pack.
Remove the four
screws that fasten the
controller cover to the
underside of the
scooter frame.
Turn the
speed pot to
full rabbit.
Set your multimeter to
measure resistance.
Disconnect the main
harness (7a) from the
controller.
Insert multimeter probes into
the main harness connector
7a at pin 8 and pin 2 (blue
wire and orange wire). See
figure 22.
Insert the multimeter probes
into the main harness connector
7a at pin 1 and pin 8 (blue wire
and yellow wire). See figure 23.
Note the resistance reading.
Are both readings
within 500 ohms of
each other?
Replace the
controller.
Open the control
panel.