Buzzaround XL_SG_REVA_100711
4
ABOUT THE BUZZAROUND XL™ SERVICE GUIDE
This service guide provides you with the information necessary to troubleshoot the Golden Technologies Buzzaround XL
GB116/GB146. The troubleshooting scenarios in this manual consist of procedures that enable you to systematically trace
and correct faults in the system. Appendices A and B include instructions on how to measure voltage and continuity with
a multimeter. Appendix C includes a copy of figure 11 that may be printed separately. Appendix D contains flow charts of
the more complex troubleshooting procedures.
Before troubleshooting, check the following:
•
Make sure that the circuit breaker is reset.
• Visually check terminals for corrosion. Check wires for missing insulation.
• Make sure that the batteries are fully charged and are in good working order.
When possible, keep sets of
known good batteries of various ratings in your shop at all times. The Buzzaround XL uses either two (2) 12AH
or (2) 18AH batteries. Problems that surface during troubleshooting are often due to the fact that the batteries are
not fully charged or can not hold their charge.
•
Make sure that the electrical connections are secure.
Unplug the connectors and make sure all of the pins
are seated properly. Push the pins back into the connector housing if necessary. Make sure that the battery
terminals are tight.
NOTE: If you get to a point during troubleshooting where you cannot continue, call tech support at 800-624-6374.
BUZZAROUND XL COMPONENTS
The Buzzaround XL is a battery-operated scooter with a controller that monitors the system and beeps when it detects a
fault in the system. The Buzzaround XL was designed to operate within a range of between 18 - 24 volts (V) of direct
current (DC).
The Buzzaround XL control system is made up of the following components:
NOTE: The number after the component refers to the components position on
figure 11 on page 10.
• Circuit Breaker (1)
• 12V Batteries (2 and 3)
• Battery Harness (4)
• Power Harness (5)
• Dynamics R-Series Controller (6)
• Main Harness (7)
• Front Intermediate Motor Harness (8)
• Rear Intermediate Motor Harness (9
)
• Motor/Brake Assembly (10)
• Brake (11)
• Control Panel (12) includes Key Switch and Speed Control
• Throttle Pot (13)
• Charger Harness (14)
• Off-Board Battery Charger – (not shown in illustration)
NOTE: Parts and service must be authorized by the Golden Technologies Service Department. Unauthorized
parts or service may void the warranty. For more information, contact the Golden Technologies Service
Department at 800-624-6374 or parts@goldentech.com.