26
FIGURE 22. FRAME HOOK
The Companion scooters are easy to assemble.
Make sure the key is out of the key switch
before assembling your scooter.
WARNING! Pinch/Crush Hazard!
CONNECTING THE F R A M E SECTIONS
1. Position the front and rear sections of the
frame as shown in figure 21 so that they
align properly.
2. Pull up on the T handle to lift the front
section.
3. Once the frame hooks are properly
aligned (See figure 22), push down on the
seat post to secure the frame together.
You will hear and feel a positive “snap”
sound to confirm that the front and rear
frames are connected.
4. Raise the tiller.
BATTERY INSTALLATION
1. Install the batteries onto the scooter.
2. Reconnect the batteries. See figure 18 on
page 25.
3.
Wrap a Velcro™ strap around each
battery to secure them in place. See
figure 23.
FIGURE 21. CORRECT FRAME ALIGNMENT
FRAME HOOK
ALIGN
VELCRO
TM
STRAPS
FIGURE 23. BATTERY INSTALLATION