L.E.D. light
L.E.D. light
From motor
To outlet
115-120V A.C.
DC Power
Bottom view of
Transformer
Transformer
Plug
PR-756MC
25 in.
25 in.
PR-756L
27 in.
27 in.
PR-505SM
23 in.
23 in.
PR-505M
24 in.
24 in.
PR-505L
27 in.
27 in.
Install two 9 volt batteries
in transformer for battery
backup (See page 7)
(batteries not included)
3. Place the chair in the desired
position in the room, keeping it 25"
away from the wall. If placing the
chair into a corner, keep it 25" from
the wall as shown. See distance
chart below for your model.
W
all
Side
View
Corner
Top
View
25"
25"
25"
PA
TENTED
Distance Required From Wall When Reclined
Model Number
Wall
Corner
Model Number
Wall
Corner
4. Adjust the leg levelers on the bottom of the chair if necessary to level the chair.
Some high pile carpets can obstruct the footrest operation by rubbing against
it. Raise the levelers to a height above the pile.
5. Slide the hand control from between the back and arm out toward the back of
the chair. Secure the cord into the quick release cable clamp located above the
magazine pocket on the arm of the chair.
CHAIR OPERATION MAXICOMFORT
1. To recline the back of the chair, press button (S1) and hold until the back
reaches the desired position. Then release the button.
2. To bring the back of the chair to an upright position, press button (S2)
and hold until the back reaches the desired position. Then release the button.
3. To raise the foot rest and seat, press button (S3) and hold until the foot rest
reaches the desired position. Then release the button.
4. To lower the foot rest, seat, and lift the chair, press button (S4) and
hold until the footrest closes, then release the button. If you want to lift the
INSTALLATION MAXICOMFORT MODELS
1. Remove the transformer from the transformer box (located behind the lower outside
back) and install two 9 volt alkaline batteries into the sockets on the transformer.
2. Plug the transformer into a 115-120V 60Hz A.C. outlet and connect the power
cable from the chair into the transformer as shown. Power cable is located under
the chair attached to the motor shaft with white zip tie. Remove zip tie, extend
cable under and out behind the chair.
4
