Golden wheel CS-471, Instruction Manual

2] INSTALLING THE HANDWHEEL

1. Fit handwheel ① close to the main shaft bushing,
   rear ②.
2. Align the handwheel with thread groove ⑤ in the
   main shaft. Tighten the first screw ③ of the hand
   '-wheel, then tighten screw ④.

3] INSTALLING THE BELT COVER

1. Install two belt cover supports ① to the machine
   arm.
2. Install belt cover B ② to belt cover supports ①
　 using screws ③.
3. Attach belt cover A ④ to belt cover B ② using
   screws ⑤.
4.Fix belt cover A on the table using wooden screw
  ⑥ and washer ⑦.

4] ADJUSTING THE PEDAL

◆ Installing the connecting rod

Install connecting rod ② in place so that connecting
rod ② is at right angles to motor control lever ①.
Connect the connecting rod with pedal adjusting pla
-te ③ so that the rod is also at right angles to the 
pedal.

◆ The angle of the pedal

The tilt of the pedal can be changed freely by adjus-
ting the length of the connecting rod.
To change the tilt of the pedal, loosen the adjusting 
screw and advance or retract the connecting rod.

5] CLEANING

    Waste thread, dust, dirt, etc., buld-up around the feed dog or the shuttle may cause malfunction
    of the machine.
    Clean periodically according to your frequency of use.
    1. Clean around the feed dog after removing the throat plate.
    2. Clean the inside of the shuttle race body by taking out the shuttle body after removing the 
       cover of the shuttle race body.

- ２ -