10
MOUNT STERN SIDE H-FRAME
Note: For this step, ensure the Stern Side H-Frame is being used.
Note: Hinge Bushings are preinstalled on Side Beam.
1.
Align the mounting holes on the Stern Side H-Frame hinge
plate with the Hinge Bushings located on the Side Beam as
shown in Figure 8.
Note: Stern Side H-Frame should be oriented so that the Cylinder
Mounting Cross Support overhangs the stern side Cross Beam as
shown in Figure 7.
2.
Insert one (1) 1/8” Cotter Pin into one (1) 3/4" x 5”
Hinge Pin,
bending the tines of the Cotter Pin outward and apart,
securing the Cotter Pin within the Hinge Pin.
3.
Attach a Lollipop Washer to the open end of the Hinge Pin.
4.
Slide the Hinge Pin through the hinge plate as shown in
Figure 8.
5.
Insert one (1) Loll
ipop Washer and one (1) 1/8” Cotter Pin into
the protruding end of the Hinge Pin, bending the tines of the
Cotter Pin outward and apart, securing the Cotter Pin within
the Hinge Pin.
6.
Repeat this step for the opposite side of the Stern Side H-
Frame.
PARTS REQUIRED TO MOUNT STERN SIDE
H-FRAME
Stern Side H-Frame
Lollipop Washer
(4)
1/8” Cotter Pin (
2)
3/4” x 5” Hinge Pin (
1)
Figure 8
Figure 7
Summary of Contents for Tornado 1-CYLINDER
Page 3: ...3 ...
