13
MOUNT HYDRAULIC CYLINDER cont.
Note: Ensure Hydraulic Cylinder(s) are tightly fastened as
described in previous step before continuing.
1.
Align the upper Hydraulic Cylinder mounting hole with the
corresponding holes on the H-Frame as shown in Figure 12
& 13.
Note: The H-Frame may need to be lifted and rotated upward to
allow proper alignment.
2.
Insert one (1) 3/4” Cylinder Pin into the cylinder mounting
plate through the Hydraulic Cylinder upper mounting hole
as shown in Figure 13.
3.
From the inside of the mounting plate, insert one (1) 3/8” Hex
Bolt through the mounting plate and the hole on the Cylinder
Pin shown in Figure 13.
4.
Attach one (1) 3/8” Lock Washer and one (1) 3/8” Hex Nut to
the protruding end of the Hex Bolt and fasten with
appropriate wrench until secure as shown in Figure 13.
PARTS REQUIRED TO MOUNT HYDRAULIC
CYLINDER
Hydraulic Cylinder (1)
3/8” Lock Washer (1)
3/8” Hex Nut (1)
3/8” x 4
-
1/2” Hex Bolt (
1)
3/4” Cylinder Pin (1)
Figure 12
Figure 13
Summary of Contents for Tornado 1-CYLINDER
Page 3: ...3 ...
