9
ATTACH LOWER CYLINDER MOUNT**
Note: Ensure lower Cylinder Mount is between both Side beams
when mounting.
1.
Align the holes on the Lower Cylinder Mount with the
corresponding holes on the Side Beam as shown in figure 6.
2.
Attach one (1) 1/2” Flat Washer to
three (3
) 1/2” x 3
-
1/2” Hex
Bolts and insert into the corresponding holes as shown in
Figure 6.
3.
Attach one (1) 1/2" Flat Washer, one (1) 1/2" Lock Washer, and
one (1) 1/2" Hex Nut to each of the three (3) protruding ends
of the Hex Bolts and hand tighten.
Note: It is important not to over tighten Hex Nuts to allow for
Lower Cylinder Mount adjustability.
4.
Repeat these steps for the other side of the Lower Cylinder
Mount.
Note: Please return to this step when instructed to fully tighten
hardware with appropriate tools.
PARTS REQUIRED TO MOUNT LOWER
CYLINDER MOUNT
1/2
” Flat Washer (
12)
1/2
” x
3-
1/2” Hex Bolt (
6)
1/2
” Lock Washer (
6)
1/2
” Hex Nut (
6)
Lower Cylinder Mount
Figure 6
Summary of Contents for Tornado 1-CYLINDER
Page 3: ...3 ...
