6
4. ADJUSTING THE EPILOGUE 3/4 FEET
When the Epilogue 3/4 is set in position, the 4 adjustable corner feet must be
adjusted as follow.
The two front feet are only set to avoid the speaker to balance if it moved. They must
go down to the floor without pressure. The weight of the front part of the Epilogue 3/4
is and must be on the pointed central foot.
The back feet, on the contrary must be use to raise the back of the speaker to make
the front to back horizontal. Use a bubble level to adjust that level.
In addition, separate adjustment of the right and left back feet provide a left/right
horizontal adjustment.
If the speaker has to be moved later, the two back feet will have to be recessed until
the speaker can be rolled on its back rollers.
5. ASSEMBLY OF THE FULL EPILOGUE (only for Full Epilogue Setup)
The Full Epilogue System is made of, for each channel :
•
One Epilogue 3 or Epilogue 4 Sub-Bass.
•
One Epilogue 1 lower Satellite mounted vertically on top of the Epilogue 3/4.
•
One Epilogue 2 mounted on its side (the larger sides being horizontal).
•
One Epilogue 1 upper Satellite mounted vertically in inverted position (upside
down, the tweeter becoming the lower driver).
You must prepare each of these speakers and the parts of the Epiframe 1 before
starting the final assembly. Please carefully execute the following steps :
A. Lower Epilogue 1 preparation
•
Dismount the gold plated top plate from the Epilogue 1 that will be assembled in
the lower position.
•
Mount where the golden plate was the silver steel plate provided with the
Epiframe 2. Attach it with the provided silver screws.
•
Mount into the bottom threaded hole one of the black pointed steel bars provided
with the Epiframe 2. Tighten it using a strong screwdriver inserted in its lateral
hole.
