GOLDMUND MIMESIS 22S - Analog Preamplifier -10
3
CONTROLS & UTILIZATION
The Goldmund Mimesis 22S is designed to capture, control, shape and nurture the fragile
source inputs, supporting adjustment of volume and balance to deliver your desired output
signal. The primary control functions supporting these processes are outlined below.
3.1
STANDBY
To activate the preamplifier (set to ON) put it into STANDBY ON mode by pressing the
SET/PWR (
1
) and the MUTE/PWR (
3
) buttons simultaneously.
To deactivate the Preamplifier (set to OFF) press these same SET/PWR (
1
) and
MUTE/PWR (
3
) buttons simultaneously once more.
In standby mode, the two red Leds near the PWR button will be illuminated intermittently
(approximately every five seconds).
3.2
INPUT SELECTION
To select the source you want to listen to, use buttons ‘IN1’ to ‘IN7’ (
2
) to activate each of
the 7 input options. When the input is activated, the Led on the button corresponding to the
selected input will be illuminated.
3.3
VOLUME ADJUSTMENT
The right-hand volume level adjustment knob (
7
) is used to adjust VOLUME. If volume is
set to a value of zero, outputs will be muted.
