9
9
25
24
Tab
31
13
36
8
8. Connect the Upper Wire Harness (36) to the Lower
Wire Harness (65). Attach the Upright (13) to the
Frame (1) with three M8 x 25mm Button Screws (33)
and three M8 Split Washers (59).
Tip: Avoid pinch-
ing the Wire Harnesses during this step.
65
33
33
33
59
59
1
9. Identify the Left Pedal (24), which is marked with an
“L” sticker. Using an adjustable wrench,
firmly tight-
en
the Left Pedal
counterclockwise
into the left arm of
the Crank (31). Tighten the Right Pedal (not shown)
clockwise
into the right arm of the Crank.
IMPOR-
TANT: Tighten both Pedals as firmly as possible.
After using the exercise cycle for one week,
retighten the Pedals. For best performance, keep
the Pedals tightened.
Adjust the Left Pedal Strap (25) to the desired posi-
tion, and press the end of the Left Pedal Strap onto
the tab on the Left Pedal (24). Adjust the Right Pedal
Strap (not shown) in the same way.
10.
Make sure that all parts are properly tightened before you use the exercise cycle.
Note: After assembly is
completed, some extra parts may be left over. Place a mat beneath the exercise cycle to protect the floor.
