44
7
6.
Attach the Backrest Frames (10) to the Bench
Frame (1) with an M10 x 156mm Bolt (39), two
M10 Washers (32), and an M10 Nylon Locknut
(47). Do not overtighten the Locknut; the
Bracket Frames must be able to pivot easily.
Insert the Backrest Bracket (11) into the slot in
the Bench Frame (1) and engage the Adjustment
Pin with Tether (38) into the Bench Frame and
one of the holes in the Backrest Bracket.
Attach the tether on the Adjustment Pin (38) to
the bottom of the Bench Frame (1) with an M4 x
16mm Black Screw (54).
Tighten the M10 Nylon Locknuts (47) used in
steps 1–4.
8.
Press three 45mm Square Inner Caps (26) into
the Leg Lever (6). Press a 25mm Round Inner
Cap (50) into the indicated end of the Weight
Tube (15).
Attach the Weight Tube (15) to the Leg Lever (6)
with an M8 x 58mm Bolt (33), two M8 Washers
(76), the 10mm Spacer (29), and an M8 Nylon
Locknut (77).
Press the 25mm Angled Outer Cap (25) onto the
other end of the Weight Tube (15).
7.
Attach the Seat (13) to the Bench Frame (1) as
shown with four M6 x 16mm Bolts (44).
6
7
8
32
47
38
54
1
6
29
77
33
25
26
26
26
15
50
76
76
13
Wide
End
1
39
11
32
10
