6
1.
Orient the Water Bottle Holder (6) and the
Upright (3) as shown.
Slide the Water Bottle Holder (6) upward onto
the Upright (3).
While a second person holds the Upright (3)
and the Water Bottle Holder (6) near the Frame
(1), insert the Wire Harness (73) upward
through the Upright.
Tip: Avoid pinching the Wire Harness (73).
Insert the Upright (3) into the Frame (1). Attach
the Upright with three M8 x 16mm Button
Screws (53).
1
1
73
53
53
53
6
3
2. Identify the Left and Right Handlebars (82, 83),
which are marked with “Left” and “Right” stick-
ers, and orient them as shown.
Have a second person hold the Left and Right
Handlebars (82, 83) near the Upright (3).
Locate the Pulse Wire (88) inside each
Handlebar.
Insert the Pulse Wires (88) into the holes in the
sides of the Upright (3) and pull them upward
out of the top of the Upright.
Tip: Avoid pinching the wires.
Attach the Left
and Right Handlebars (82, 83) to the Upright (3)
with two M8 x 55mm Button Bolts (85) and two
M8 Locknuts (70).
Slide the Water Bottle Holder (6) downward to
the Frame (1). Attach the Water Bottle Holder
with an M4 x 35mm Screw (74).
2
To make assembly easier, read the
information on page 5 before you begin.
Avoid pinching the
Wire Harness (73)
Avoid pinching
the wires
88
74
73
88
70
70
85
82
83
3
1
6
