10
4
Battery
Covers
Batteries
Screws
7
7. The Console (4) can use four D batteries (not
included); alkaline batteries are recommended.
Do not use old and new batteries together or
alkaline, standard, and rechargeable batter-
ies together.
IMPORTANT: If the Console has
been exposed to cold temperatures, allow
it to warm to room temperature before you
insert batteries. Otherwise, you may dam-
age the console display or other electronic
components.
Remove the screws, remove
the battery covers, and insert batteries into the
battery compartments.
Make sure to orient the
batteries as shown by the diagrams inside
the battery compartments.
Then, reattach the
battery covers.
To purchase an optional power adapter, call
the telephone number on the cover of this
manual. To avoid damaging the console,
use only a manufacturer-supplied regulated
power adapter.
Plug one end of the power
adapter into the receptacle on the console; plug
the other end into an outlet installed in accor-
dance with all local codes and ordinances.
8
8. Untie and discard the wire tie on the Main
Wire (42).
While a second person holds the Console (4)
near the Upright (2), connect the wires on the
Console to the Main Wire (42) and to the Sensor
Wires (28).
Insert the excess wire into the Upright (2) or into
the Console (4).
Tip: Avoid pinching the wires.
Attach the
Console (4) to the Upright (2) with four M4 x
16mm Screws (87).
4
42
87
2
Avoid pinching
the wires
28
