15
22.
Steps 22-51 are shown from the rear of the
weight rack. See the CABLE DIAGRAMS on
pages 32 and 33 to identify cables as you
assemble them.
Identify the Butterfly Cable (71).
Attach the
Butterfly Cable to the Right Arm (11) with an M8 x
19mm Shoulder Bolt (85) and an M8 Locknut
(78).
Do not overtighten the Locknut; the
Butterfly Cable must pivot easily.
21. Attach the Foot Plate (9) to the Center Base (2)
and the Backrest Upright (8) with four M10 x
19mm Button Bolts (77) and four M10 Locknuts
(79).
See steps 3–8, 12, and 14–20. Tighten all of
the Bolts, Screws, and Locknuts.
85
22
71
11
78
77
79
79
9
2
8
77
21
23. Route the Butterfly Cable (71) over a V-pulley
(60). Attach the V-pulley, a Large Cable Trap (61),
an M10 Washer (84), and two Full Guards (39) to
the Backrest Upright (8) with an M10 x 62mm
Button Bolt (88) and an M10 Locknut (79).
Make
sure that the Large Cable Trap is oriented to
hold the Cable in the groove of the V-pulley.
23
88
61
60
84
79
8
71
39
79
39
