12
11
11. Note: There may be two screws (E) preattached
to the Left Upright (66). If so, remove and dis-
card the screws.
Attach the Latch Housing (67) to the Left Upright
(66) with two #10 x 3/4" Screws (8); start both
Screws, and then tighten them. Make sure
that the large hole in the Latch Housing is on
the indicated side.
Locate the Latch Pin Assembly (68). Remove the
knob from the pin. Make sure that the collar and
the spring are on the pin. (Note: If there are two
collars, place one on each side of the spring.)
Insert the pin into the Latch Housing (67). Then,
tighten the knob onto the pin.
12
12. Move the treadmill to the desired location for use
if you have not already done so (see HOW TO
FOLD AND MOVE THE TREADMILL on page
19).
Place the Dumbbells (65) in the dumbbell tray.
CAUTION: Do not fold or move the treadmill
with the Dumbbells in the dumbbell tray.
Always remove the Dumbbells before moving
the treadmill.
Dumbbell
Tray
65
13. Make sure that all parts are properly tightened before you use the treadmill. If there are sheets of plas-
tic on the treadmill decals, remove the plastic. To protect the floor or carpet, place a mat under the treadmill.
Note: Extra hardware may be included. Keep the included hex keys in a secure place; one of the hex keys is
used to adjust the walking belt (see pages 21 and 22).
67
E
8
66
68
Knob
Spring
Large Hole
Pin
Collar
