Gold's Gym Stride Trainer 410, User Manual

20

Most treadmill problems can be solved by following 

the simple steps below. Find the symptom that 

applies, and follow the steps listed. If further assis-

tance is needed, see the front cover of this manual. 

SYMPTOM: The power does not turn on

a.   Make sure that the power cord is plugged into a 

surge suppressor and that the surge suppressor is 

plugged into a properly-grounded outlet (see page 

13). Use only a single-outlet surge suppressor that 

meets all of the specifications described on page 

13. IMPORTANT: The treadmill is not compat-

ible with GFCI-equipped outlets and may not be 

compatible with AFCI-equipped outlets.

b.  

After the power cord has been plugged in, make 

sure that the key is inserted into the console. 

c.   Check the power switch located on the treadmill 

frame near the power cord. If the switch protrudes 

as shown, the switch has tripped. To reset the 

power switch, wait for five minutes and then press 

the switch back in. 

SYMPTOM: The power turns off during use

a.   Check the power switch (see the drawing above). 

If the switch has tripped, wait for five minutes and 

then press the switch back in.

b.   Make sure that the power cord is plugged in. If the 

power cord is plugged in, unplug it, wait for five 

minutes, and then plug it back in.

c.   Remove the key from the console, and then        

reinsert it.

d.   If the treadmill still will not run, please see the front 

cover of this manual.

SYMPTOM: The console displays remain lit when 

you remove the key from the console

a.     The console features a display demo mode, de-

signed to be used if the treadmill is displayed in a 

store. If the displays remain lit when you remove 

the key, the demo mode is turned on. To turn off 

the demo mode, hold down the Stop button for a 

few seconds. If the displays are still lit, see THE 

INFORMATION MODE on page 18 to turn off the 

demo mode.

SYMPTOM: The displays of the console do not 

function properly

a.     Remove the key from the console and UNPLUG 

THE POWER CORD. Next, remove the five indi-

cated #8 x 3/4" Screws (4).

   Carefully lift the Motor Hood (48) upward, and then 

slide it forward and off. Make sure that the Motor 

Hood does not get caught by the tabs on the sides 

of the Motor Hood.

TROUBLESHOOTING

Reset

Tripped

c

4

4

a

48

4