GP-L200N User Manual
33
Field
Description
access commands. The value 1 indicates that the client is in the
charge of the access commands.
Ackpolicy When WMM packets are being transmitting, AP receives an echo
request. The value of 0 indicates that the AP does not send back an
echo request, which brings positive effect for WMM. The value 1
indicates that the AP generates a response to the request.
Note:
The GP-L200N provides standard WMM settings. If you want to modify the
parameters, please refer to the WMM settings of your WMM products.
(3)
DLS (Direct Link Setup)
The GP-L200N provides DLS function. Suppose that there are two WMM devices.
Enter the MAC address of a WMM device in the DLS setting of the other device,
and then connect the two WMM devices to the GP-L200N. In this way, the two
WMM devices can transmit message directly.
If you want to configure WMM DLS, do as follows:
Step 1
Prepare two wireless network cards (A and B) and one GP-L200N.
Step 2
Enable the DLS function on the
Advanced Wireless Settings
page.
Step 3
Enable the DLS function of wireless network cards, enter the MAC
address of wireless card A in the
WMM
page of the wireless network
card B, and then click
Apply
.
