GOLFBOARD OWNER’S MANUAL
20
3.2.3 Additional Provisions for Stability Bar Installation on Thumb Throttle Board
In addition to the installation of the stability bar described in section 2.17.2, the thumb throttle
version of the GolfBoard comes supplied with an externally mounted water resistant connector;
this links the electronic controls mounted in the stability bar with the tray of the GolfBoard.
Follow the steps outlined in this video to ensure the stability bar is installed correctly:
VIDEO LINK: https://www.youtube.com/watch?v=8O_F299pRYY
3.2.4 Attaching Your Golf Bag
The following steps provide instruction on the proper attachment of a standard golf bag to the
stability bar of your GolfBoard on both the Sport and Thumb Throttle version of the product.
Step #
Step Description
1
Remove the strap on the top bag support
by pulling out on the buckle release arm.
2
Expand the lower strap all the way
outwards until it reaches its maximum
strap loop size.
3
Place your bag onto the stability bar bag
support base.
4
Wrap the 2’’ strap on the top bag support
around your bag and through the carry
handle.
5
Feed the strap through the buckle.
6
Pull the strap tight and secure the buckle
by firmly pressing inwards on the buckle
release arm.
7
Pull up and seat the lower strap around
the flat circular base of your golf bag.
8
Perform the same tightening operation as
explained for the top strap, making sure
that your bag is secured from both front
and back, and side to side movement.
CAUTION
Check to ensure that all components of the stability bar are securely mounted and no
damage occurred during transport before operating your GolfBoard.
NOTICE
The steps outlined in the video above provide critical information for the installation of the
Thumb Throttle Stability Bar. The video can be opened with any standard web browser
and viewed on YouTube. If you have trouble viewing the video, please contact GolfBoard
at 1-888-328-2841 before performing this installation.