Customer Service Support: 1800 224 278 |
Page 16 of 24
18
ALLEN KEY
2
19
SAFETY CARD
1
WARNING!
PLEASE READ THESE INSTRUCTIONS IN ORDER AND THOROUGHLY,
BEFORE COMMENCING INSTALLATION. FAILURE TO DO SO WILL RESULT IN
HAVING TO DISASSEMBLE THE TRAMPOLINE AND START AGAIN.
9 Assembly Instructions (Frame)
NOTE:
CHOKING HAZARD
- Small Parts. Not for children under 3 years.
ADULT ASSEMBLY REQUIRED
- Contains small parts, sharp points and sharp edges.
1. Connect the Top Rail Tube (2) with T-Joint (1),
as shown in the picture below.
Make sure on T-
joint (1), the side with welded socket faces
away from the centre of the trampoline.
2.
Install the W-Shaped Leg Tubes (3), Vertical
Leg Tubes (4) with T-Shaped Joint (1). Ensure
the locking pins are aligned with locking holes
and pin locks into the secured position.
3.
Put all assembled Top Rail Frames together as
shown as below.
4. When it is done correctly, the trampoline frame
should look like the illustration below.